Difference between revisions of Transient astigmatism

Line 1:

The official EM article says this [[double vision]] effect [https://endmyopia.org/ruis-glasses-and-headaches-9-75-to-6-00-progress/ occurs when you reduce too quickly] and is temporary, so you should stop reducing and wait for it to disappear.

~~When~~ cylinder ~~overcorrection was first added to your lens-induced set of problems~~, your ~~eyes remember when it was added in, as the~~ visual cortex will compensate by ~~negating~~ that ~~overcorrection past~~ a ~~certain distance. Once you've reduced to that point, you will temporarily experience that cylinder. If you don't push for fast reductions via~~ [[double vision]]~~, this effect will be less pronounced (according to [[User:User]])~~

If you reduce a cylinder too quickly, you will confuse your visual cortex, which will compensate by adding a cylinder that appears only on one side of a focal plane during the [[double vision]] resolution.

Do not get cylinder correction for it, as you would just put extra load on your visual cortex for no reason, slowing down your progress.

If it's too noticeable, you can step up, but [[User:User]] believes that you must use lots of close-up near the edge of where the cylinder appears, because there would otherwise be no stimulus to clear it. If you have a huge cylinder only in the distance (very low myopia with huge cylinder), it's tricky, since stepping up to hide it would not solve the problem.

@@ Line 1: / Line 1: @@
 The official EM article says this [[double vision]] effect [https://endmyopia.org/ruis-glasses-and-headaches-9-75-to-6-00-progress/ occurs when you reduce too quickly] and is temporary, so you should stop reducing and wait for it to disappear.
-When cylinder overcorrection was first added to your lens-induced set of problems, your eyes remember when it was added in, as the visual cortex will compensate by negating that overcorrection past a certain distance. Once you've reduced to that point, you will temporarily experience that cylinder. If you don't push for fast reductions via [[double vision]], this effect will be less pronounced (according to [[User:User]])
+If you reduce a cylinder too quickly, you will confuse your visual cortex, which will compensate by adding a cylinder that appears only on one side of a focal plane during the [[double vision]] resolution.
 Do not get cylinder correction for it, as you would just put extra load on your visual cortex for no reason, slowing down your progress.
 If it's too noticeable, you can step up, but [[User:User]] believes that you must use lots of close-up near the edge of where the cylinder appears, because there would otherwise be no stimulus to clear it. If you have a huge cylinder only in the distance (very low myopia with huge cylinder), it's tricky, since stepping up to hide it would not solve the problem.